Mission Style End Table with Slate, Part 3

Here is an update on the end table project. The complex part are the curved sides which bow out slightly from each side to match the curve of the top. The picture at right shows the bottom of the table with a coat of gel stain that fills the grain of the oak. I'm following my Mission Style finish recipe that I blogged about earlier. After the stain dries, I'll sand it and then spray a brown dye.

Economy and Reduced Complexity

Using solid quarter-sawn white oak would have been costly and showing flake on all four sides of the legs would have been difficult. This project almost entirely uses veneer. The core of the legs is ¾" plywood with ¼" MDF sandwiched between them. Quarter-sawn white oak veneer is glued to all four sides.

Enabling the Curved Sides

To create the bowed sides, I've cut a 15° slot into the sides of the legs. I don't want the curve all the way to the floor, so the challenge is only having the slot partially down the leg. Veneer allows me to cover the slot on bottom part of the leg. I sawed the slot the entire length of the leg, then filled the slot with filler where it wasn't required. Veneer was glued over the top and I exposed the slot again with a small diameter router bit on my router table.